General planning comments and questions.
Hi All,
I want to use claim digger but failed so far. When i open it and click the "select revised project" then at that moment only few projects appear in the dorp down list and i cannot see the full list. why is it so?. How to get the pop in of full list?
regards,
Kashif
Hi All,
I want to use claim digger but failed so far. When i open it and click the "select revised project" then at that moment only few projects appear in the dorp down list and i cannot see the full list. why is it so?. How to get the pop in of full list?
regards,
Kashif
Hi;
I have got separate schedule for Procurement,mobilization and construction from our sub-contractors.How to make these all as one project?
Regards
Dear All,
How can we generate a cumulative late curve from the resource usage spread sheet
in P6. Your valuable remarks are highly acceptable..
Regards.
Sunil.
Dear Planners,
I am producing time scheduling for Pipe manufacturing, it is production line and the schedule is EPC (Eng. Procurement and Construction) the size of critical is massive as most of the activities are critical, is this right?
Regards,
Moutaz
Dear All
Currently I am handling a project having a one month delay ,I want to prepare man power histogram , The histogram i prepared is based on Baseline and now it is not reflecting the exact situation of site due to delay
1. Is it possible tp prepare a Histogram based on Actual start and expected to finish, or Expected to start or Expected to Finish?( I am using P3 as a software )
2.While preparing this, is there any need to remove Target program?
thanks
Dear All
Currently I am handling a project having a one month delay ,I want to prepare man power histogram , The histogram i prepared is based on Baseline and now it is not reflecting the exact situation of site due to delay
1. Is it possible tp prepare a Histogram based on Actual start and expected to finish, or Expected to start or Expected to Finish?( I am using P3 as a software )
2.While preparing this, is there any need to remove Target program?
thanks
hi All;
Rafael Davila & Mike Testro Specially;
I understand that upon approval of baseline, it seves as a contractual document.
How about S curve and Manpower histogram ? Does it constitute of a committment to comply with the manpower, equipment and performance aspect?
Does it work against us if the actual deviate too much from the planned ?
And does it relate to acceleration cost calculation etc?
Anyone has guide to SDK?
I tick SDK piror to installation but couldn't activate it.
