Dear All,
What are the steps to check for an activty which does not have any sucessor?
With Regards,
Mangesh
Open Link for an activity
Forum Sponsor
Top Posters
Josephus Enot
1 posts
Julian Pegg
1 posts
Peter Nagy
2 posts
Raymund de Laza
17 posts
Syed_Asad
0 posts
Tony Greyvenstein
0 posts
Ahmed Al-Jubouri
13 posts
Umar Alvi
3 posts
Sibusiso Mahlalela
0 posts
Michael Samanyayi
3 posts
Dear Rafael,
Thanks a lot for the valuable suggestion, will definitaley impliment this now and in future also. I just shifted to P6 after a break of 3 years ( I used p3 before that). Lots of changes, after trying for different fields i again moved into planning and scheduling as it gives me utmost pleasure.
Will opt for PSP now.
With Regards,
Mangesh Khuspe
Mangesh,
I always try to keep an up to date Template Job I use to store all my favorite Layouts, filters, formulas, reports etc then I can use it as a template on new jobs or as a reference to transfer my layouts, filters, formulas, reports ... easier than searching all over.
This was an easy filter but sometimes even the most basic filter can be complex, like a look-ahead filter for example, same goes for reports.
Best regards,
Rafael
Thanks Gary and Rafael ,
It worked
With Regards,
Mangesh
Thanks Gary and Rafael ,
It worked
With Regards,
Mangesh
To Quote Rafael:
"If not pre-defined you shall define it yourself"
Create a filter where successors = blank
its does not work out in p6
Just apply a filter for Activities without Successors/Predecessors it would be too primitive to run the schedule to get a report, same as scrolling all activities, especially if a schedule of thousands of activities.
The following screen display how Spider provides for such filters you can apply to the whole project or a selection of WBS phases. Look for such equivalent filter in P6. If not pre-defined you shall define it yourself. After this it shall always be available at a single click of the mouse and error proof, no single activity missed.