PROFILE PRINTING PROBLEM

S
Shazia khan 👤 Member for 18 years 1 month
Planning, Scheduling & Programming Discussion
R
Rodel Marasigan 👤 Member for 19 years 7 months
· Permalink

Shazia,

Can you send me the screenshot of what you save and screenshot of you getting when open it again so I can visualize what’s going wrong?

S
Shazia khan 👤 Member for 18 years 1 month
· Permalink

Dear Sir



Thanks for your reply.



I have save layout with valid name for example.



enginnering s-curve



I select Profile and made engineering s-curve based on Aictivity Select.



then i save it



while i try to open it it was open but s-curve was diffrent means parallel.



Please advise.



How can save a profile layout.



Best regards














R
Rodel Marasigan 👤 Member for 19 years 7 months
· Permalink

Shazia,

Savings is on the layout and not on print. Make sure when saving the layout give a meaningful name so you can open it again.

S
Shazia khan 👤 Member for 18 years 1 month
· Permalink

Dear sir



Thanks for your reply.



I try a new thing (new for me) i have set prit tab timescale



start of atcivity and finished date of activiy with one week gap start and end (00) in s-curve



and all s curves are perfact.



sir new problem i am not able save my layout ,



i ahve save but while open again it not like waht i had save



Please advise



Thanks & Best Regards


R
Rodel Marasigan 👤 Member for 19 years 7 months
· Permalink

Shazia,



Click Print Preview then click Page Setup.

On Page Setup dialog box select Options tab then remove all the tick under Print except for Profile. Then select Page tab and tick Fit timescale and enter 1.



If the view is not good try to reduce the % Normal size (i.e 65%) and select Fit timescale again and click apply.


Forum Sponsor

Top Posters

Julian Pegg
1 posts
Peter Nagy
2 posts
Raymund de Laza
17 posts
Syed_Asad
0 posts
Tony Greyvenstein
0 posts
Ahmed Al-Jubouri
13 posts
Umar Alvi
3 posts
Sibusiso Mahlalela
0 posts
Michael Samanyayi
3 posts
Simon Gumede
0 posts