Printing in A0 size plotter-MS Project
Featured Partner
Top Posters
Zine Eddine
2 posts
Alex Lyaschenko
27 posts
mxsiegel
0 posts
Mattvtek
0 posts
Gareth Evans
3 posts
PP Admin
3, 129 posts
Rajkamal Tangirala
5 posts
Rahul Kumar
1 posts
blake333_
0 posts
Jeamiell Ostrovsky
2 posts
Our Partners
Kannan,
Andrew’s suggestion have worked for me for years, I have a small laser printer but my clients want to print the reports in Tabloid size, I setup a PDF in tabloid size and then e-mail it, my clients always can print it on tabloid paper even when I cannot as my printer is limited to letter and legal size paper.
This is what I did with sample project to mimic your issue and had to play a little bit with the scale until I got what I wanted.
In your case because you have the printer that can print A0 paper size you should be able to do it without the need of a PDF. Still my favorite way is to use PDF as this is my electronic record. In case you do not have a PDF printing software recommend above all the original Adobe Acrobat, if on a budget then try free PrimoPDF as the new version works with multiple worksheets on a single workbook, not as nice as Adobe Acrobat but many free printers are bad at this.
http://www.primopdf.com/index.aspx
If you are in need to test it you can send me the file and I will make a PDF on A0 paper size, then you can try to plot it. You can contact me through PP e-mailing and then I will provide you with my e-mail for the transferring of files.
Best regards,
Rafael
Use the custom size in the pdf print software and change it to the equivalent AO size, as I have said it works for me.
Regards
Andrew
Hi friends,
Thanks for your replies.
I tried to change the scale from 100 to 200%, still its not working. Now I have to look into the settings of the plotter.
I want the whole schedule in a single A0 size paper. so not possible to convert to PDF, since it will come in multiple pages only.
Kannan
Try increasing scale size as fit to one page wide will not rescale if it fits on 100%, try with 200%.
I always plot to a pdf before printing to AO seems to work for me.
Andrew
Dooh
Should have paid more attention! Still wise to check this and the page set up, fit timescale to page
Mal,
I believed that was not the problem because Kannan already mentioned have that parameter range Feb 2010 to Dec 2011.
On the print window within MSP there is a timescale option, I would set this to 1 month after your programme end date and check Page set up, view and check fit timescale to end of page
Kannan,
There is some adjustment on Plotter Configuration depends on the type of Plotter (refer to Plotters Manual). To avoid that problem the work around is print to PDF and print PDF to plotter.
Hope this help.