Logo on Layouts

I have do some tests before. Same logo in different format, so different file size. Then same printer driver, some work, some not (even in preview). In most situation, due to the size of logo file is too big. I check the print queue size also, not only just print out or not). Some successful print out but the logo from colour to B/W only.



Then select those successful logo file with different printer driver to same printer, do the test again. Some printing failure. Those printer drivers are standard, postscript and PCL.

Hi All,,



I have met this problem in the past..I found this problem comes from big file size..once I convert the file to Jpg formate or gif..with smaller size.(you can adjust the size through Adobe photoshop or Illustrator)..it works.



If the Printer Memory is supporting the big file size..it will print..it depends upon the memory of the printer mainly.



Ali Hamouda

===========================================================

hi Mark,

try to make new layout without (Layout - Transfer), then try t oinsert the logo, i think it will work. if not, convert the logo from BMP to PMT this is a guaranteed method



regards,

Ahmed

You mean that the path is "C:\P3WIN" do you not? The difference between your answer and this one may be the answer to your problem.

My experience: -

- If the logo file size is big, fail to print

- The printer driver support the logo format or not, same printer may have standard driver, postscript drive, PCL driver. All have different result

- Location of logo file. Long path is not recommended.

We are using P3 Ver 3.1 with Windows XP. We have the latest service pack installed. We have tried different logo’s and different printers.

LOGO is printed in P3 without any problem if it is properly pasted from image file and also your printer set up is correlate with the Printer

It does print logo’s .May someproblem with printing harware.Like less memory or so.