Can not start ot setup P3 after install ODBC?

Submitted by Wassem Habboub on
Primavera Project Planner - P3

Member for

22 years 8 months
Member for 22 years 9 months
Submitted by Alex Wong on Wed, 2005-11-09 22:32
Permalink

If you running in a server environment, this would happened. The reason that it cannot lock a serial no because you may have a session still active. Try to kill that session and install ODBC driver again

HTH

Alex

Member for

20 years 6 months
Member for 20 years 7 months
Submitted by Zhang Haixiang on Wed, 2005-11-09 21:09
Permalink

I haven’t had this problem before when i using informaker/MS Access to make report.



I’m not sure if using ODBC to access P3 need a serial number,i think only P3 batch or RA require it.



May be there are some other problems,you’d better call P3.



The last choice is to format you hard disk and then reinstall everything.

Member for

22 years 10 months
Member for 22 years 10 months
Submitted by Ronald Winter on Wed, 2005-11-09 10:53
Permalink

After uninstalling both programs using the Windows Control Panel, you need to reboot your computer. It is not sufficient to just delete some of the files. If you did not use the Windows Control Panel to remove the program, then do so. Good luck!

Member for

20 years 2 months
Member for 20 years 3 months
Submitted by Wassem Habboub on Wed, 2005-11-09 06:41
Permalink

Hello Christian Adrian De Vera,



I delete the pervasive file, and also the P3WIN file/folder

but i still have the same massage



Thanks,

W.H